If you want to smoke out of a bong but you don’t have one around, don’t fret. You can make your own out of a water bottle by using few simple tools. Just make sure, you are using it in a place where smoking is legal. Making a basic water bottle bong is not too much hard. Firstly Obtain a plastic water bottle, we want to use a bottle that is just the right size for bong-making purposes.
A standard 16.9 ounces plastic bottle should do the trick. Plastic water bottles are nicer than soda bottles because they won’t leave any sticky residue. You can remove the label of the bottle if you want. You do not have to leave any water inside the bottle. However, if you want the bong to stand upright then you can leave some in to weigh it down. This is not a traditional bong because it does not force the smoke to through the water. However, the homemade bong can be made quickly and easily.
Step by step instructions of how to make a water bottle bong
1. Remove the lid and set it aside, you will not need it.
2. After that, tear off a little piece of aluminum foil, the piece will serve as the bowl, it should be approximately 2.5 inches by 2.5 inches, 5 cm by 5 cm.
3. If you only have aluminum foil of lighter weight then simply fold the bottle over to make it thicker before forming 2.5 inches by 2.5 inches square.
The aluminum foil piece should be large enough to cover the mouth of the water bottle & fold over the edges.
Look at your bottle if 2.5 inches by 2.5 inches doesn’t seem large enough then tear off a larger piece of aluminum foil.
4. Apply the foils and then make the bull depression large enough to contain your Earth but don’t push down so hard that you tear the aluminum foil.
Aluminum can be toxic if used improperly such as by inhaling, heating, or ingesting it five-six.
5. Poke holes in the aluminum foil ball.
Make sure that the holes are far enough apart that they do not break the bowl. Be careful that do not to try to poke holes so large that they break the ball.
6. Punch a hole in the side of the bottle, do not try to make the hole too big. Gently poke a tiny hole using a needle or straight pin the Wiggle around a bit to make the hole a little bigger.
7. Now make the side hole bigger with a pair of scissors, make it 1 inch 2.5 cm in diameter approximately to start, and do not rip the bottle.
8. Press down on the hole to indent the plastic slightly then gently enlarge the hole.
9. Start by making the hole a little on the small side, you can always enlarge it later if you need to. But you can’t make it smaller.
10. After that, Pack the bowl if pieces of your herb fall through the ball then the holes you punched are too large. Take the aluminum foil and try again. This time making smaller holes.
Now start smoking and inhaling gently
There are many health risks associated with plastic consumption. The chemical additives in most plastic items especially in plastic water bottles are harmful to our health as well as our environment. Now Let’s know all those harmful which we will face after the consumption of plastic:
- It Increases the levels of toxicity in our body due to direct exposure to harmful chemicals such as lead, cadmium, mercury.
- Exposure to carcinogens is a big risk which can grow up the chances of causing dangerous diseases name Cancer.
- A major disruption of our endocrine system leads to cancer, suppression of our immune system which makes us susceptible to several other illnesses.
- It can also cause birth defects as well as developmental problems.
- Billboard Advertising & Large Format Advertising
- How To Get Rid Of Cankles
- Salty Taste In Mouth: Causes & Treatment
- How To Make A Water Bottle Bong
- How To Skateboard For Beginners